85332 Curb Guard Set Kit 6'8, 7'2 Plow Straight Blade Western Defender, Fisher HS, Snowex LT, Blizzard

A new set of Genuine Curb Guards 85332. These are for the Western Defender 6'8" and 7'2", Fisher HS 6'8" & 7'2", SnowEx 6800LT & 7200LT, and Blizzard 680LT, 720LT plows.

This curb guard set is made specifically for the lighter duty straight blade plows. They enable you to go right up to the edge of your plowing surface without damaging the outer edge of your plow. This also gives you more of a wear surface, extending the life of the cutting edge. 

This curb guard is made of steel. It is 1/4" thick , it is 5" tall on the face, 20-3/4" wide. There are 4 holes but only 2 are used for each plow. Setting the tape inside the weld the bolt pattern on center is 2" and 17" for the 6'8" plows and 3" and 19" for the 7'2" plows, the holes are 5/8" made for a 1/2" carrage bolt. May fit other plows check the bolt patern. 

*Note: These can not be installed with a worn cutting edge, If your stock edge has alot of wear these will sit below that edge, make sure your cutting edge measures close to 5" if not that will need to be replaced as well. 

If you do need a new cutting edge as well part #'s are below
6'8" plow 1/4" thick (93668, 93678, B61458, B81062.) Thicker 3/8" edge (85287, 85289.)
7'2" plow 1/4" thick (93669, 93679, B61531, B81073.) Thicker 3/8" edge (85288, 85290.)

Here is a link to the instructions and parts list.

This kit includes DS 85333, PS 85334 and Bolt Bag 76384.